Selden Rodkicker Universal Mast Bracket, 508-237-02

The Seldén Group is the world’s leading manufacturer of mast and rigging systems in carbon and aluminium for dinghies, keelboats and yachts. The range was extended with deck hardware in 2008.

The Group consists of Seldén Mast AB in Sweden, Seldén Mast A/S in Denmark, Seldén Mast Ltd in the UK, Seldén Mid Europe B.V. in the Netherlands, Seldén Mast SAS in France, Seldén Mast Inc. in the USA and Seldén Mast Asia Ltd in Hong Kong.

Our well known brands are Seldén and Furlex. The worldwide success of Furlex has enabled us to build a network of over 750 authorized dealers covering the world’s marine markets. So wherever you sail, you can be sure of fast access to our service, spare parts and know how.

Note: Special Order Only

Mounting instruction 508-237-02

Fasteners: MRT M6x20 screws are included in the kit. Any stainless M6 or 1/4” cheese headed screws can be used. Minimum length 20 mm (5/8”)

Tools needed:

Drill bit 5-5.2 mm (for M6)

Drill bit ø6.5 or pen for marking

Thread tap M6

Torx-Key T30

Mounting:

1. Adjust the bracket so that its bases are fully aligned with the aft surfaces of the mast.

2. Mark out the four outer holes of the bases with a ø6.5 mm (~1/4”) drill bit or a pen.

3. Drill holes ø5 mm and tap M6 or similar imperial.*

4. Screw the bracket to the mast.

5. Mark out the eight remaining holes according. to step 2.

6. Remove bracket and finish the six holes.

7. Apply locking adhesive to the screws and fit the bracket firmly. Do not overtighten - mast wall can be thin. If a thread would fail, drill and fit a ø6.4 (1/4”) rivet. Length: 18mm (3/4”). Seldén part no.167-002. *)

CAUTION! Cables and halyards inside mast. To avoid damage when drilling holes, use a depth stopper on the drill bit